Wynberg · Kenilworth · Plumstead
Heat pump installation and repairs in Wynberg, Kenilworth and Plumstead
Domestic hot water heat pumps and swimming pool heat pumps for homes, guesthouses and small complexes in Wynberg, Kenilworth and Plumstead. Correct sizing, sensible siting and repairs that address the cause rather than the symptom.
A heat pump moves heat rather than generating it, which is why it can heat water for a fraction of the electricity a resistive element uses. That advantage disappears if the unit is undersized, installed in a cold or shaded position, or asked to heat a pool through a windy Cape winter without a cover. Sizing and siting matter more than the badge on the casing.
Repairs usually involve the parts that sit between the heat pump and the rest of the system: a failed controller, a circulation pump, a blocked strainer, a gas leak on the refrigerant circuit, or a defrost fault that leaves the coil iced. On pool units, water chemistry and flow rate cause as many failures as the refrigeration circuit, so we check both before quoting a repair.
What the work covers
- Hot water heat pump sizing, installation and integration with existing geysers
- Pool heat pump installation, plumbing connections and electrical supply
- Diagnosis of no-heat, tripping, icing and noisy-running faults
- Refrigerant leak detection, repair and recharge
- Controller, sensor, circulation pump and fan repairs
- Servicing: coil cleaning, strainer cleaning, flow and pressure checks
Signs worth acting on
- Hot water is lukewarm or runs out faster than it used to
- The unit runs constantly without reaching its setpoint
- Ice on the outdoor coil that does not clear
- The pool takes days to gain a degree, or loses heat overnight
- A controller error, a tripped breaker or a noisy fan
Local detail in each suburb
The same service is specified differently in each of the three suburbs we cover, because the buildings, access and plant positions are different.
Questions
Heat pump installation and repairs questions
Does a heat pump work in Cape winter?
Yes, but output drops as air temperature falls, which is why sizing has to use winter conditions rather than a summer average. A unit sized on summer figures will underperform exactly when you need it.
Can a heat pump replace my electric geyser element?
It can carry the base load, and many installations keep the element as backup for high-demand days. The right arrangement depends on household size, roof space and where the cylinder sits.
Why is my pool heat pump icing up?
Low airflow, low refrigerant charge, a cold night with high humidity, or a fan fault. Icing that persists after the unit shuts down needs diagnosis rather than a thermostat change.
How long does a heat pump last?
With annual servicing and correct water or air flow, a domestic unit can give many years of service. Coil corrosion and neglected filters are the two things that shorten that most.
Assessment
Request a heat pump installation and repairs assessment.
Tell us about the property and the equipment. The enquiry is taggedWynberg, Kenilworth and Plumstead and sent to the team directly.
Email info@reyds.co.za