7 min read
Start with the door and the air
Before anything is measured, look at the door. A gasket that has hardened, a closer that no longer pulls the door shut, or strip curtains that have been pushed aside all let humid air in. In a busy kitchen the door opens far more often than the room was designed for, and that alone can lift the temperature through a service.
The second air question is the condenser. If the outdoor unit sits in a yard with a wall on two sides, or in a plant room with a louvre that has been covered, it cannot reject heat. A condenser running in its own hot air loses capacity steadily as the day warms up, which is why the room holds overnight and fails during trading.
Then look at ice and water
Ice on the evaporator is a symptom with several causes: a defrost cycle that never completes, failed heaters, a timer that has drifted, or a drain that has frozen and backed up. Ice insulates the coil, so the unit runs longer, which makes more ice. It does not resolve itself.
Water on the floor is usually the same story from a different angle: a blocked or frozen drain. Left long enough, water damages panels and floors, and the room starts to smell. Both are cheap to fix early and expensive to ignore.
Finally, check the controls and the duty
A controller reading that does not match a separate thermometer points to a probe problem, and a probe reading the wrong place will make a healthy room look sick. It is worth confirming with an independent reading before anything is replaced.
If the room has changed use, the duty has changed too. A room built to hold packaged drinks will struggle with warm product going in every morning, and no repair will fix a specification mismatch. That is when a capacity review is more useful than another call-out.
In short
- Check door seals, closers and strip curtains before suspecting the refrigeration circuit.
- Confirm the condenser has airflow; boxed-in plant loses capacity as ambient temperature rises.
- Ice and water usually mean defrost or drainage, and both get worse if left.
- A changed product mix can make a correctly working room the wrong size.
Questions on this topic
Can I just turn the thermostat down?
It usually makes things worse. A lower setpoint means longer running and more frost, and if the underlying fault is airflow or defrost, the room will still fail, just later in the day.
How often should the room be checked?
A daily temperature reading by staff and a service visit every six months covers most commercial rooms. Rooms with heavy door traffic benefit from quarterly checks.
Is a warmer room always a refrigerant leak?
No. Leaks are one cause among several, and they are less common than door, defrost, airflow and probe problems. A proper diagnosis tests before recharging.