Guide

Sizing air conditioning for an older Cape home

Why floor area alone gets sizing wrong in pre-1980 houses, and what to measure before choosing a unit for a room in Wynberg, Kenilworth or Plumstead.

6 min read

Floor area is only the starting point

A rule-of-thumb figure per square metre will get you into the right family of equipment, and no further. Two rooms of the same size can need very different capacities if one has a north-facing bay window and the other has a shaded wall and a small window. In older southern suburbs houses the difference is often larger than in new builds, because the glazing is single, the walls may be double-brick without insulation, and the ceilings are high enough to hold a lot of warm air.

The practical measurements are the glazing area and its orientation, whether the room is shaded for part of the day, the ceiling height, how many people use the room and what else generates heat in it. A kitchen or a room with a home office and two screens is a different load from a bedroom used at night.

High ceilings and old windows change the behaviour

High ceilings are not automatically a problem. They hold a reservoir of warm air that a well-positioned unit can mix and cool, and they give space for a high-wall unit where it will not blow directly onto a bed or a desk. What they do change is how long the room takes to recover after the doors have been open, and how noticeable stratification becomes if the air is not circulated.

Sash windows and original timber frames leak air. That is not a reason to oversize, but it is a reason to expect a unit to work harder on a windy day. Where a room has been draught-proofed and insulated, the same capacity will perform better, so the assessment should reflect the building as it is now, not as it was built.

Zones beat one big machine

Extensions are the most common source of comfort complaints in these suburbs. A new living area with more glass and a lower thermal mass will heat faster than the original rooms, and a single unit trying to serve both will either freeze the old section or never satisfy the new one.

Treating each area as a zone, with its own indoor unit or its own ducted damper, costs more upfront and performs far better in use. It also means one failure does not take out the whole house, and rooms that are not used can be left off.

In short

  • Measure glazing, orientation, ceiling height and occupancy, not just floor area.
  • Do not oversize to compensate for draughts; fix what you can and size for the room as it is.
  • High ceilings are workable if the air is circulated and the unit is well positioned.
  • Extensions usually need their own zone rather than a share of the main system.

Questions on this topic

Can I use an online calculator and buy the unit myself?

You can, and you may land in the right range. What a calculator cannot see is the wall you want to mount on, the route to the outdoor unit, the drainage fall and the electrical supply, which is where most installation problems come from.

Is a bigger unit always better in a hot room?

No. Oversizing cools the air quickly without removing enough moisture, so the room feels cold and clammy, and the unit short-cycles. Correct sizing with good airflow is more comfortable than extra capacity.

Do I need a separate unit for a home office?

If the office is used during the day and the rest of the house is not, a separate unit or zone is usually worth it. It lets you cool one room without running a whole-house system.

Talk to us

Have a specific property in mind?

Guides are general. A property in Wynberg, Kenilworth or Plumstead needs its own assessment, so send the detail and we will take it from there.

How urgent is it?

Tagged as a Wynberg enquiry and sent to info@reyds.co.za. We use your details only to respond.